Netmos 9865 pci parallel port help

the hal stuff

Looks good:
In the interior square part of your board, there are three jumpers spaced out in a row.
The far right one is pullup/down for 2-9 and it shold be on 1-2(pulldown). It looks right in the pic
The middle one decides if you're using 2-9 for input or output. It should be 1-2output, looks right in the pic.
The far left one controls the other ports, which are used for input (probes/limit switches/estop etc). It's set to pulldown on mine.

Looks different:
In your pic - upper right corner is a jumper that sets the COM ports to 5V or ground. It should be 5V. It looks like you've got it set to ground? On mine it's set to 5V and it takes the 5V input on the bottom left of your board and sends it to each 4030 (from the COM to the DIR+, and then the DIR+ and PUL+ are jumpered together on the board.)

Switched the jumper now getting a RTAPI error.

That's a different problem. Did you run a latency test?

I have tried the test. Not sure what I need to do. Thanks for all your help.

chadrat6458 wrote: Switched the jumper now getting a RTAPI error.

Which error?