LinuxCNC Install using MX Linux 19.4 - Geared Toward New Users

Give this a try, in the [RS274NGC] section of the .ini file change:
to:  

made change and here is the end of the report
 
 

That looks like some type of network issue to me, hm2_eth is to do with the ethernet for the mesa card.

I understand but I have do nothing to the connection to the mesa card.
Not sure if this means anything but a made a dummy Axis gui and it seem to load up fine. When I click on the wire connection a window in the upper right says it has established connection
There are LEDs on the mesa card showing communications. The connection on the card is showing a green and yellow LED on.
I had a WIFI card in the PC and have WEB service, I did not have that before this load of the new software, and it would start QTPLasmaC fine and would run it too. Maybe I should remove the WIFI card.
I am going to call it a night and go to bed
Thanks for your help

I did remove the WIFI card no change
This is another error that comes up too
 

That doesn't make sense, the path listed there should be the USER_M_PATH from the .ini file.

Are you using master branch (2.10) or 2.9 branch?

Can you post the result of this:


Edit: It seems that I have made a mistake with the expected location of the codes directory in package installations. I will try to fix it before the weekend if you can respond to the above two questions.