Mesa Configuration Tool

I'll have to add the 7i78 spindle.

JT

Is there any readme on how to add .bin files for a new board to this? I have the Mesa 7i76eu, successor to the 7i76e, and have downloaded the firmware files from the mesa site but am unsure of how to add them to the configuration tool.

Any help is appreciated,
-Aren

7i76EU has been added to Mesa CT just now. I've not tested the configuration yet.

JT

Appreciate the prompt action, I also got a reply from the Mesa folks that you can select and build configs with 7i76E as well.

-Aren

Yes, 7I76E hal and ini files will work with a 7I76EU.

The added 7I76EU features (output modes and spindle mode)
would not be supported, but these are just controlled by parameters
that  can be setp'ed in the hal file.

The firmware files are however different

I've added support for the 7i76EU, just need to figure out what features it has over the 7i76E. Good to know the pin names are the same.

JT