How do you pass shielded servo motor cables through the cabinet wall/panel?

I don't think I'm ever unwilling to apply new learnings but I can't implement the suggestions from this thread on existing machines.
I will say some of my learnings building a plasma table have been particularly brutal, in particular noise management....

Indeed all this servo shielding stuff is highly confusing.
Why most asian servo manufacturers use these crappy Molex connectors at the motor end while recommending shielding at both ends?! Yaskawa, Delta, Panasonic, ...

Meanwhile all European servos use proper shielded M23 connectors...

johnbl wrote:

Indeed all this servo shielding stuff is highly confusing.
Why most asian servo manufacturers use these crappy Molex connectors at the motor end while recommending shielding at both ends?! Yaskawa, Delta, Panasonic, ...

Meanwhile all European servos use proper shielded M23 connectors...

An M23 connector with backshell and terminals costs nearly as much as some Asian servos . More if you buy the crimping tool.