PlasmaC Fiber laser 1Kw head height control + auto focuas

     170 L / min @ 13 Bar

Hello.
Can You be so nice and share how you connected capacitive amplifier to controller (shematic with pin numbers)?
Thank You a lot

taloot wrote:

ok but u dont need it, 
u can do those from mesa board,,, also chinese Breakout have this,the 5$ one
so we need less parts, involved, to make the laser working,...
our goal here is to make ultimate fiberlaser controller, with easy to use and install , 
i make and applet have all this in qtpy,, i can control laser directly and gas, 
 
 

I am looking at purchasing the Raytools BM110 auto focus head. In the manual, it describes using the ETC-F100 controller to handle the auto focus functions. Is this needed? Or can it be controlled with Mesa hardware and is it something that you've already accomplished?


Edit: My mistake, I was reading the manual for the BM111. The BM110 does not use the ETC-F100 controller

Hello.
I have this head haaslti.com/laser-components/robotic-end-effector.html
In the front has a capacitive sensor what electronics need to interface this sensor?
For focus has a dc servo that is easy controllable by linuxcnc but what about capacitive sensor
that reads the distance from material?

We were finally able to figure out how to interface a BCL_AMP capacitive height sensor to LinuxCNC: forum.linuxcnc.org/plasma-laser/51568-in...e-sensor-to-linuxcnc