Setup for plasma cutting need help
21 Jul 2012 16:27 #22275
by andypugh
Replied by andypugh on topic Re:Setup for plasma cutting need help
ricky_a wrote:
Have you seen:
wiki.linuxcnc.org/cgi-bin/wiki.pl?Simple...e_and_produce_G_code
Is there a free program to create G codes similar to sheetcam
Have you seen:
wiki.linuxcnc.org/cgi-bin/wiki.pl?Simple...e_and_produce_G_code
Please Log in or Create an account to join the conversation.
21 Jul 2012 17:22 #22281
by ricky_a
Replied by ricky_a on topic Re:Setup for plasma cutting need help
no we have not, we are trying that
Please Log in or Create an account to join the conversation.
21 Jul 2012 17:40 #22285
by ricky_a
Replied by ricky_a on topic Re:Setup for plasma cutting need help
Have just looked closer at it we already tried it, can i see.
Are there other options
Are there other options
Please Log in or Create an account to join the conversation.
22 Jul 2012 09:22 #22313
by Rick G
Replied by Rick G on topic Re:Setup for plasma cutting need help
Please Log in or Create an account to join the conversation.
28 Jul 2012 14:47 #22557
by BigJohnT
Replied by BigJohnT on topic Re:Setup for plasma cutting need help
mcenter wrote:
Seems like I was wrong, you can install Librecad from the source on 10.04...
John
I was setting one of my computers up after installing 12.04, and couldn't find qcad in the repository. Ubuntu has switched to librecad.org/cms/home.html in the repo. It appears to be very similar to Qcad.
Seems like I was wrong, you can install Librecad from the source on 10.04...
John
Please Log in or Create an account to join the conversation.
Time to create page: 0.629 seconds