Mach3 -> Camtronics -> Parallel P Replacement

Got threading good enough to do what I need. Thank you everyone for the help getting here.

Thread Cut Video

Moving off the lathe to the Mill. I am not finding out how to slow down the jog speed of the Z axis going up and down. The jog speed slider in the GUI only changes X and Y jog speed.

Trying to find out how to connect the Z axis jog speed to the same jog slider speed that changes X and Y.

Any ideas?

rdeeming wrote: Thread Cut Video

Not public

rdeeming wrote: Moving off the lathe to the Mill. I am not finding out how to slow down the jog speed of the Z axis going up and down. The jog speed slider in the GUI only changes X and Y jog speed.

Well, _that's_ not expected behaviour.

Can we see your HAL and INI to try to get to the bottom of that?

Changed to public

Hal and ini files for the Mill attached